0 Comments 12:05 am

How do you turn a sheet of pork skin into a bowl of crisp, airy bites? Simmer it until tender, dry it thoroughly, and fry it briefly in hot oil. This recipe for pork rinds takes time, but most of that time belongs to the oven.

Once you see how rinds are made from pork skin, the dramatic puff makes sense: the dried pieces expand rapidly in the hot fat. A thermometer and a small test batch make the last step much easier to manage.

How pork rinds are made: the three stages

Knowing how pork rinds are made helps you plan. To make rinds from pork skin, allow plenty of drying time. The skin first simmers in water until pliable. Next, gentle oven heat removes moisture and leaves the pieces hard and dry. Finally, a short dip in hot oil turns them light and crisp. If you have wondered, “how are pork skins made into those crunchy snacks?” this sequence is the answer.

This pork rinds recipe uses raw skin with the hair removed and as little fat attached as possible. Ask a butcher for pork skin, sometimes sold as pork rind, and request a trimmed piece. A thin layer of fat is fine, but thick patches can keep the pieces from drying evenly. You’ll need a large pot, a rimmed baking sheet, a rack, a deep-fry thermometer, and a slotted spoon or spider.

Ingredients and timing

For one small bowl of finished rinds, gather:

  • 1 pound raw pork skin, hair removed
  • Water to cover, plus more as needed
  • About 4 cups neutral frying oil or melted lard, enough for at least 2 inches in your pot
  • 1/2 teaspoon fine salt, or to taste
  • 1/4 teaspoon smoked paprika, optional

Allow about 2 hours for simmering and 4 to 8 hours for drying, followed by a few minutes of frying. Thickness and oven performance affect the drying time, so use the texture of the skin as your guide. For pork rinds, this recipe yields different amounts depending on trimming and expansion; fry a test piece before committing the whole batch.

Simmer and trim the skin

Cut the skin into several large, manageable pieces. Put them in a pot, cover with water by an inch, and bring to a boil. Lower the heat so the water bubbles gently. Simmer for 1 1/2 to 2 hours, adding hot water if needed to keep the skin submerged. It is ready when a fork meets little resistance and the skin bends easily without falling apart.

Lift the pieces out and let them cool until you can handle them. Place them fat side up on a cutting board. With a spoon or a small knife held nearly parallel to the board, scrape away as much soft fat as you can without cutting through the skin. This step takes a little patience and makes the drying more even.

Cut the trimmed skin into roughly 1-inch squares. They will shrink as they dry and expand when fried, so give them room on the rack. Wash the board, knife, and your hands after handling the raw pork.

Dry until hard

Heat the oven to 200°F. Arrange the squares in a single layer on a rack set over a rimmed baking sheet, with a little space between them. Dry for 4 to 8 hours, turning the pieces once or twice. Thicker pieces may take longer than thin ones.

Look for pieces that are dry all the way through, hard, and brittle, with no soft or tacky patches. Break a cooled piece to check its center: it should snap rather than bend. Continue drying any flexible pieces. This is the quiet work behind a crisp pork rind recipe; surface dryness alone is not enough.

Let the dried pieces cool while you prepare to fry. Keep the cooking area clear, use completely dry utensils, and set a paper-towel-lined tray nearby. Water can cause hot oil to splatter, so never add wet skin to the pot.

Fry in small batches

Pour the oil into a heavy, deep pot, leaving at least several inches of empty space above it for bubbling. Clip a deep-fry thermometer to the side, keeping its tip in the oil without touching the pot. Heat to 375°F over medium heat. Keep a lid nearby and stay with the pot while the oil is hot.

Lower one dried square into the oil with the slotted spoon. It should expand quickly, becoming pale golden and crisp in about 30 seconds to a minute. Lift it out and let it cool briefly before tasting. If the test piece puffs well, fry a small handful at a time, gently moving the pieces so they have room to expand. Return the oil to 375°F between batches.

Transfer each batch to the lined tray as soon as it has puffed and the bubbling has subsided. Sprinkle with salt while warm; add the paprika if you like. Keep seasoning away from the pot, and let the oil cool completely before handling it.

Season and serve

Serve the rinds soon after frying, when their crunch is at its best. A squeeze of lime at the table adds brightness, although it will soften the surface if applied too far ahead. They also make a crisp accompaniment to a creamy dip or a bowl of beans.

Many pork rind recipes call for chile, garlic powder, or vinegar powder. Start with a small pinch of any dry seasoning, toss, and taste before adding more. This recipe for fried pork rinds leaves the seasoning simple so the warm, savory flavor of the skin can come through.

If the pieces stay hard

The most common disappointment is a piece that remains dense or chewy instead of puffing. First check the thermometer: oil below 375°F may not give the skin the quick burst of heat it needs. Bring the oil back to temperature and test another piece. If it also stays hard, the remaining dried skin may still be flexible inside; cool it, return it to the 200°F oven, and dry until it snaps. Let it cool again before testing another piece in fresh hot oil.

Related Posts